Electrician in Florence, AL

Hiller charges a flat $79 diagnostic fee, credited back to you when you book the work with us.

Once the electrician traces the fault, you get a fixed price for the fix from a set rate sheet and approve it before anything starts. That keeps Lauderdale County homeowners out of the guessing game an hourly rate creates.

Yes, in almost every case. Fuse panels were sized for a 1930s household and cannot safely carry the loads a modern home puts on them.

Older Florence neighborhoods still hold plenty of 60-amp fuse services. The common workaround, putting a larger fuse in the slot, removes the protection the fuse was there to provide. A properly sized breaker panel restores that protection, adds capacity for central air and a modern kitchen, and clears the objection most insurers and home inspectors raise.

A breaker trips to protect the circuit, so repeated tripping points to too much load on that circuit, a fault in the wiring, or a breaker that has worn out.

Start by noting whether it trips when one particular appliance runs, which usually means the circuit is overloaded, or at random, which more often points to a wiring fault or a failing breaker. Older Florence homes frequently run whole rooms on a single circuit added long before microwaves and window units. An electrician can tell you whether you need one new circuit or a panel with room to grow.

Yes. Most electrical work beyond swapping a device requires a permit, and we pull it for you.

Alabama licenses electricians at the state level because bad work is a fire and safety risk. We file with Florence or Lauderdale County, complete the job to the National Electrical Code, and meet the inspector so the work is signed off. In the downtown historic districts, we account for the added review before starting.

A standby generator wired to a transfer switch starts on its own when the power drops and runs the circuits you choose until service returns.

North Alabama sits in a corner of the state that draws severe storms in spring and fall and freezing rain in winter, and both can leave neighborhoods dark for days. Sized correctly, a standby unit carries the heat, the refrigerator, the well pump, and any medical equipment without extension cords or fuel cans. We size it, wire the transfer switch, and coordinate the gas connection.

It is one of the cheaper ways to protect a house full of electronics, especially in a region that takes this much summer lightning and storm activity.

A whole-home unit installs at the panel and clamps voltage spikes before they travel into your wiring, appliances, and HVAC boards. Grid switching and nearby strikes both send surges down the line, and the damage rarely announces itself until a board fails weeks later. Panel-level protection pairs well with plug-in units at sensitive equipment.